How To Fix A Door That Won T Latch

Use a utility knife to trim out any piece of wood around the edges of the latch hole in the jamb. Always a good deal.

How To Fix A Door That Won T Stay Closed Diy Family Handyman

There are 3 ways to fix this problem that is described in this video.

How to fix a door that won t latch. Tightening the hinges is good though so no harm done. There are many ways to get a door latch misalignment corrected. In that case take the hinges from the frame.

Door latch still stuck in place. Note how the latch moves when it is directly depressed and when pressure is released. If the screws have been stripped they will not tighten in the holes and youll need new ones.

Lift the door up to relieve the pressure on the hinges and tighten the screws. Using the wood chisel scrape away small parts of the door frame to create enough space for the door to latch. Remove one of the screws on the jamb side of the hinge and drive in a 3-in.

Using a phillips-head screwdriver tighten all door hinges so that none is loose. If you find that the latch contacts the strike plate too high or too low make sure all the doors hinge screws are tight. If you have a door that isnt latching properly a simple modification to the strike plate will almost always solve the problem.

File down strike plate Take a Phillips screwdriver and take the screws off the strike plate to remove it. Remove the Strike Plate Remove the top screw first then the bottom. Scrape away from the flat side of the mortise or the edge that would stop the door from moving to an open position.

If that doesnt solve the problem try this trick. The simplest and most common action to take will be to tighten all the screws around the hinges. There is no difference in how the handle must be manipulated to move the stuck door latch Press down on the door latch itself with your finger without manipulating the door handle.

Repairing a door that doesnt latch properly might seem like a quick and easy door repair and it can be but there are a few little tricks that make the job much easier. The jamb latch hole should be flash with the strike plate hole for the door to latch properly. Get Results from multiple Engines.

Close the door to check that the latch locks into place. Take a big flathead screwdriver and hammer to tap the bottom lip of the strike plate really hard several times. If it still opens without turning the door knob meaning it didnt latch completely then go to step 2.

Doors that wont latch are one of the most common problems around the house. Ad Search For Relevant Info Results. Fixing a door that wont latch is really that simple.

Tighten the Hinges First. If the door is sagging and will not line up with the latch check the door hinges. This would force down the wood inside the latch hole.

Ad Search For Relevant Info Results. Materials For The Door Latch Fix. In this awesome video tutorial by The Honest Carpenter on YouTube you will learn how to fix a door that wont latch.

Always a good deal. Get Results from multiple Engines. With just a few tools some cardboard and a few minutes of time you can fix this issue.

Now try closing the door and give it a push. In this article and in my video I described 3 steps you can take.

10 Steps To Fix A Door That Won T Latch